Express Logic: industrial-grade IoT device-to-cloud connectivity platform

Express Logic announced the X-Ware IoT Platform, for fast, safe, secure, industrial-grade connectivity of deeply embedded IoT sensors, devices, edge routers, and gateways. The X-Ware IoT Platform is built on top of Express Logic’s high-performance ThreadX RTOS and NetX Duo dual IPv4/IPv6 TCP/IP stack. The X-Ware IoT Platform leverages all the benefits of NetX Duo and introduces new IoT protocol support for IPv6 over Low Power Wireless Personal Area Networks, Message Queue Telemetry Transport, Constrained Application Protocol and Lightweight M2M.

The X-Ware IoT Platform is designed for the smallest of IoT devices. For example, X-Ware IoT Platform support for an 802.15.4 radio device (using 6LoWPAN, IPv6, UDP, DTLS, and CoAP) requires only 25KB of flash memory. This gives embedded developers of safety- and security-critical IoT devices plenty of room to add NetX Secure TLS or DTLS to secure data at the socket layer or NetX Duo IPsec to secure data at the network layer.

For its part, NetX Duo has been precertified at the highest level for safety standards that include industrial safety’s IEC 61508 SIL 4, medical’s IEC 62304 Class C, automotive’s ISO 26262 ASIL D, and rail transportation’s EN 50128 SW-SIL 4, as well as consumer applicance standards UL 60730-1 Annex H, CSA E60730-1 Annex H, IEC 60730-1 Annex H, IEC 60335-1 Annex R, and IEC 60335-1 Annex R, 1998.

Through NetX Duo, the X-Ware IoT Platform is seamlessly integrated with Express Logic’s ThreadX, and both products are certified to the same SIL 4 and ASIL D levels. Both products also support all major commercial processors, providing a powerful platform for developing safe, secure, high-performance device-to-cloud solutions in a small footprint.

Latest News from

Express Logic: FileX certified for use in safety-critical embedded systems and IoT devices
Express Logic: industrial-grade IoT device-to-cloud connectivity platform
Express Logic: TCP/IP stack for IoT development meets widely required safety standards

ZES Zimmer on testing advanced power electronics

In this video Bernd Neuner from ZES Zimmer talks to Alix Paultre for Electronic News TV at the 2017 Power Electronics Conference in Nuremberg. The discussion deals with the issues involving test and m...


Weidmüller discusses the need for a better signal and power interface

In this video Rene Arntzen from Weidmüller talks to Alix Paultre of Electronic News TV about the importance of a good signal and power interface for industrial equipment. There is currently no good ...


Mouser talks about the state of engineering development today

In this video Mark Burr-Lonnon and Graham Maggs of Mouser Electronics, a major international electronics distributor, talk to Alix Paultre about the state of engineering development today. With massiv...


Infineon launches a new family of configurable industrial drive boards

In this video Infineon explains their new family of configurable industrial drive boards at SPS-IPC Drives 2017. Intended to enable easy setup and deployment, the XMC-based automation boards can handl...


STMicro explains their STSPIN family of single-chip motor drivers

In this video STMicroelectronics explains their STSPIN single-chip motor drivers at SPS-IPC Drives 2017. The STSPIN family embeds can drive motors efficiently and with high accuracy, with an advanced ...